I was extracted dragonica .dat file by offzip. When I opening the nif file by NIFSKOPE, I see the name .dds file. But, the dds file are number and I spent a lot of time to find right dds file to choose to import to NIFSKOPE.
When I updating dragonica game, I saw the name file .dds ,then it merrge to .dat. Is there way to extract .dat file with name.?
Important information: this site is currently scheduled to go offline indefinitely by December 1st 2023.
If you wish to donate to attempt the preservation of tools and software somewhere else before it goes down, check the GoFundMe
If you wish to donate to attempt the preservation of tools and software somewhere else before it goes down, check the GoFundMe
How to extract.dat dragonica and know file name???
-
laphonetens
- ultra-n00b
- Posts: 3
- Joined: Sun Aug 14, 2011 11:25 am
-
finale00
- M-M-M-Monster veteran
- Posts: 2382
- Joined: Sat Apr 09, 2011 1:22 am
- Has thanked: 170 times
- Been thanked: 307 times
Re: How to extract.dat dragonica and know file name???
If you can extract it with offzip then writing a bms script wouldn't be too difficult since you already it uses zlib compression.
-
laphonetens
- ultra-n00b
- Posts: 3
- Joined: Sun Aug 14, 2011 11:25 am
Re: How to extract.dat dragonica and know file name???
I don't know bms script so I post here and I hope someone help me.
-
laphonetens
- ultra-n00b
- Posts: 3
- Joined: Sun Aug 14, 2011 11:25 am
Re: How to extract.dat dragonica and know file name???
Would you like show me how it work ! .I don't know how to use it. Thanks you very much.
Re: How to extract.dat dragonica and know file name???
run mppack.exe in Folder [20090820 MPPack_repaired] in packtools
select Bind Unpack
set Target Bindpack File : For File .dat (1_cha.dat, 2_mon.dat ...)
set Result Folder : to any Folder you went (make new folder and select them)
and Execute
select Bind Unpack
set Target Bindpack File : For File .dat (1_cha.dat, 2_mon.dat ...)
set Result Folder : to any Folder you went (make new folder and select them)
and Execute